Wise Master Waving WiperTag

Wave and follow the all knowing wise one. Universal size fits any lower mounted rear wiper but can also be mounted on the top (upside down) or side.  Both decal and WiperTags are removable/detachable and UV protected against fading.  The window decal is also laminated for additional protection.  Double sided (reversible) arm fits both left and right sided wipers.

Approximate measurements:

• Arm measures 7.25" L x 3" H
• Master Window Decal measures 9.75" W x 9" H

VIRALITY RATING ⭐⭐⭐⭐⭐

 Simple installation:

1. Clean and dry rear window and wiper thoroughly
2. Attach waving arm to wiper according to the instructions on packaging.  You will be able to adjust slightly left or right as necessary.
3. Before removing back of decal, align to the correct side of the wiper for positioning. If needed, you can trim the decal to fit around the wiper arm if yours is mounted through the window.  
4. Remove decal backing, align level with minimal touching on the adhesive, and from the bottom up gently lay the decal on the window pushing out any wrinkles on the way up.  Remove and realign if needed.  Save the paper backing if you want to reuse each season.  
5. Follow up by using a credit card or something thin and flexible to push any wrinkles or bubbles towards the outside of the decal.
6. To get the most from your decal, keep your wiper blades free of dirt and debris.  Remove the WiperTag arm before entering a car wash.    
7. To remove the decal, make sure it is not freezing or it could tear.  Remove indoors or warm with a blow dryer.  Make sure your hands, window, and decal are clean and dry.  Simply pick off an edge and slowly peel off, then apply back to the original paper.  Remove WiperTag arm by tilting sideways and unlocking.  The number of times the decal can be reused varies depending on well it is taken care of.

Please check with your local and state laws regarding window decals and exterior accessories prior to ordering.